Messages

3471

General Mach Discussion / Re: I want to learn more!!! But, how & where?

« on: March 01, 2006, 04:26:40 PM »

There is going to be a CNC workshop in May that Art and I will be at (I think John P. too..) Also Art and I were thinking about doing an all Mach one here in Maine...

3472

General Mach Discussion / Re: What's the difference between FRO & F ??

« on: March 01, 2006, 04:23:55 PM »

FRO is Feed Rate Override
and F is Feed
Hope that is a help

3473

Newfangled Solutions Mach3 Wizards / Re: NEW WIZARD IDEA

« on: February 28, 2006, 05:47:06 AM »

It makes my head hurt to think about it...

3474

General Mach Discussion / Re: My motors won't move with the Motor tuning screen open...

« on: February 26, 2006, 09:02:15 AM »

Ckick on the gragh with the mouse. after that use the up and doun arrows to jog the motor.
what should work...

3475

General Mach Discussion / Re: Optimisation exe ?

« on: February 25, 2006, 07:48:22 AM »

Benny what are you looking to have Optimised?
I would like to have one that will help me take advantage of all the time in a day 

3476

Newfangled Solutions Mach3 Wizards / Re: New problem with 4 digits

« on: February 24, 2006, 07:36:03 PM »

Done for 2.65 

3477

General Mach Discussion / Re: Prope set script

« on: February 24, 2006, 07:21:01 PM »

The probe writes to 2000 = X 2001= y adn 2002 = z

I am off to add it to the Wiki

3478

General Mach Discussion / Re: Encoder as feed rate override?

« on: February 24, 2006, 09:07:47 AM »

This is like using the input as a button.... there are a few that have done that in the past but I don't know how it worked.

3479

General Mach Discussion / Re: Missing Steps or is it something else? Help!

« on: February 23, 2006, 09:01:01 PM »

I do it ALL the time.... don't feel bad!

3480

General Mach Discussion / Re: Missing Steps or is it something else? Help!

« on: February 23, 2006, 08:39:00 PM »

under config / state there is a check box about half way up

Hope that helps