Messages

2081

General Mach Discussion / Re: Thanks a bunch!

« on: October 24, 2006, 11:15:15 PM »

Nice!! you build it and they will come ...

2082

General Mach Discussion / Re: anyone know where to get an optical edge finder?

« on: October 24, 2006, 11:14:24 PM »

I used a USB video camera and it seemed to work very well You need to have it straight but that is not hard to do.. there is a video window in mach3

2083

General Mach Discussion / Re: run amuck on STOP

« on: October 24, 2006, 11:11:42 PM »

You need to press "FeedHold" and Mach3 will not miss steps when it stops

Thanks
Brian

2084

General Mach Discussion / Re: How to unlink Rapid Rate from Feed Rate Override

« on: October 24, 2006, 11:09:43 PM »

The FRO under 100% will slow down the rate that the Rapid is done at we are talking about adding a rapid override that will not change the feed... this should help with the problem that he is having.

Thanks
Brian

2085

LazyCam (Beta) / Re: Mew layer for Drill chains.

« on: October 21, 2006, 05:25:20 PM »

we will look into it :0)

2086

General Mach Discussion / Re: Program E-Stop in middle of jobs

« on: October 21, 2006, 05:15:10 PM »

You have noise in your system and it could be a ground loop put on a low pass filter and it may fix your problem... What are you dunning for drives an so on?

Tho other thing that you can do for a test is to disable to Estop input. please have the power cable in your hand to power the thing down if you need to.

2087

General Mach Discussion / Re: run amuck on STOP

« on: October 21, 2006, 05:10:32 PM »

That is new.. i never hit stop because you will loose steps... could you post a file is giving you trouble and tell me where you hit stop?

Thanks

2088

General Mach Discussion / Re: Mach 3 beginner: getting right depth of cut?

« on: October 21, 2006, 05:04:49 PM »

You need to update to Lcam that is in Rev2.x

2089

General Mach Discussion / Re: blue screen of death

« on: October 21, 2006, 05:02:33 PM »

I see that you didn't reboot

You need to uninstall the driver and reinstall. Be sure that you reboot the computer after you insall

2090

General Mach Discussion / Re: Semi ridgid Tapping Wizzard

« on: October 21, 2006, 04:59:34 PM »

I had a test version but it was taken out because there was not anyone that wanted it