1762
« on: February 12, 2015, 01:48:21 PM »
Sorry not been online for a few days.
Just looked at your xml and it seems to be the Code List hotkey that is the problem.
If you look at the pic below you have it set to 123.
What to do is go to Config menu then System Hotkeys and then click the Code List button, when the window pops up just click the red cross. Hopefully that will sort you out.
One other thing I see is you have the Enables in Ports and Pins, Outputs enabled and set up with the same pins as your motors output, that is not right. If you require enables then they should be different port/pin numbers than you have set for the motor outputs.
If it is a stepper setup then likely you do not need enables anyway, so disable them if that is the case.
Hood