1
General Mach Discussion / Re: Mach3 & Artcam ramping problems
« on: February 01, 2007, 03:32:09 AM »
Hey
Well just to make life more difficult, we have version 1.84 of mach3 and in the config dropdown there is no referance to safe z setup....and in the material setup in artcam theres no option to have a top offset but i had a thought last night, would it have anything to do with the tool start depth for example it starts at 0 and tool finishes the cut at -5 so somewhere its got to go from 0 to -5 and in a slot 8mm long i guess it will have to ramp down to do this (maybe its a numb thought but !!!)
Cheers
Well just to make life more difficult, we have version 1.84 of mach3 and in the config dropdown there is no referance to safe z setup....and in the material setup in artcam theres no option to have a top offset but i had a thought last night, would it have anything to do with the tool start depth for example it starts at 0 and tool finishes the cut at -5 so somewhere its got to go from 0 to -5 and in a slot 8mm long i guess it will have to ramp down to do this (maybe its a numb thought but !!!)
Cheers