921
General Mach Discussion / Re: Spindle DC Servo Indexing
« on: April 22, 2016, 01:40:07 AM »
If you are using the parallel port then you could use SwapAxis() to temporarily change the Spindle to an A Axis for the tool change. You would then Home the A Axis to the sensor then command a move of the amount required to get into position. Once complete you would swap the A Axis back to a spindle.
If using an external controller then SwapAxis() may not be available as only a few support it.
Hood
If using an external controller then SwapAxis() may not be available as only a few support it.
Hood