2231
General Mach Discussion / Re: Initial startup problem
« on: October 20, 2014, 07:56:03 PM »
Your G-code needs to do that, unless of course you are pressing the GoToZ button to move to Zero.
If you are doing the latter then you need to set up the safe Z, I prefer machine coords.
If it is the former then as mentioned it is your G Code that should move the Z up before moving the X and Y.
Hood
If you are doing the latter then you need to set up the safe Z, I prefer machine coords.
If it is the former then as mentioned it is your G Code that should move the Z up before moving the X and Y.
Hood