13481
General Mach Discussion / Re: Can't get the spindle/pulley calibration figured out
« on: January 01, 2011, 04:32:26 PM »
What config settings are you meaning, if the Velocity then I have explained why you can not set any higher.
From my reading of the CNC4PC manual this is what you want, ie when a full speed is commanded the pin puts out a pulse of 25KHz to the C11 which then converts that to 10v.
Hood
From my reading of the CNC4PC manual this is what you want, ie when a full speed is commanded the pin puts out a pulse of 25KHz to the C11 which then converts that to 10v.
Hood