1811
General Mach Discussion / Re: Help! Dangerous Result With Mach3 And Vista Pendant
« on: August 01, 2015, 09:24:47 AM »
On Config> Toolpath, there's a checkbox to use the radius for feedrate I think.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I see this as a killer for Mach on W10.
But before he code is loaded I can put new tool numbers into Mach 3 and enter them and they all find the G 52 work offset zero point which confirms that the tools were measured correctly and loaded correctly into the tool table.