Thanks Andrew,
Basicly I am trying to figure out how to make a sign or nameplate or any part that uses different tools for profiling,pocketing, drilling etc and load it at the same time into mach3. Vectric 2.5 D doesn't allow this. I have to make a different file for each toolpath that uses a different tool. If I use the same tool for all those operations , I can just save to Mach and run the part. I am not sure what or where the subroutine feature is located in Mach. I was hoping to be able to load the program with all toolpaths and be able to stop and change the tool as needed. Thanks again for any and all help. Are you a pilot? I see Piper 2010 as your screen name !
Thanks,
Craig