4971
General Mach Discussion / Re: The image gets flipped (mirror)
« on: January 02, 2014, 10:57:05 AM »
This is the area John was referring to.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
When I entered the first address clicked apply Mach3 did not communicate with the card. I then tried the second I/O address and clicked apply and this did not work either. I then went back and input the first I/O address click apply and magically it worked. At least until I restarted my PC and then it did not work.
Do you mybee know how to kontrol spindle in PWM mode. if I have on PWM mode it runs on full speed. komand M5 doesentz help.