781
Mach4 General Discussion / Re: Optional Stop Output
« on: March 07, 2017, 12:22:40 PM »
Daz, the M1 works just fine, I'm trying to get an output to turn on our light/buzzer during the M1 pause to let the operator know it's paused so they can go check the past and hit cycle start to finish the program. The optional stop output in Mach config only gets the handle on M1 being enabled or not.
I'm wanting a signal saying that it is in a paused state due to M1 or M0. Is this possible or should it be a feature request?
I'm wanting a signal saying that it is in a paused state due to M1 or M0. Is this possible or should it be a feature request?