Messages

261

Mach4 General Discussion / Re: Mach4 + ESS + EasyServo = Z axis problem

« on: March 17, 2021, 10:16:15 PM »

the brake activate how its done?
its not done by its self
there shuld be some relay that  relese it
this relay i advice you see how its work
because as you describe its typical z brake problem

262

Mach4 General Discussion / Re: mach4 will no hold zero

« on: March 17, 2021, 10:12:22 PM »

cheack tool offset,bater add G40 on top
also cheack if you have G54-59 on top ,and if so if the parameters are corect

263

Mach4 General Discussion / Re: Mach4 + ESS + EasyServo = Z axis problem

« on: March 17, 2021, 02:20:51 AM »

The brake its not part of electrical or driver,its just as its name brake,its mechanical brake that its default status its lock,and to release must give 24v
As i know cnc( 30years experience) its impossible use z axiss without brake even if you have air cilynder compensation
Any way you need give the brake 24 v before try move ,then when shut down you should first turn of the brake ,wait one second ,only then make driver to bb condition

264

Mach4 General Discussion / Re: Mach4 + ESS + EasyServo = Z axis problem

« on: March 16, 2021, 10:16:36 PM »

if you have only on z ,did you check the z brake output? maybe its not configurate well?

265

Mach4 General Discussion / Re: Probe 2 setup, Pokeys57cnc

« on: March 09, 2021, 04:06:30 PM »

If you look at 24dc  relay response time you can see first its "up too" that mean not constant ,and its 15ms or 6 ms i think its not long time but its can make problem with tool length measure

266

Mach4 General Discussion / Re: Probe 2 setup, Pokeys57cnc

« on: March 09, 2021, 03:15:09 PM »

I don't think relay good ide,its probe and relay response time not presics

267

Mach4 General Discussion / Re: I need a personal tutor in queens , NY or Northern NJ area

« on: March 04, 2021, 08:48:58 AM »

if its for woodworking i can help you

268

Mach4 General Discussion / Re: Serious Mach4 Mill problem with the use of cycles with G18 plane

« on: February 19, 2021, 04:26:27 AM »

we use alot with Horizontal drilling  ,but i think like thsoj,its totally not similar to milling ,first need consider offset and each side its differnt
second all cycle is different ,you must activate at least some m function to go down with Horizontal head...calculate the security...
i cant see any way to do it but only in pp ,the point that you focus that 4 years and no one see this problem ,confirm that mine thinking its corect

269

Mach4 General Discussion / Re: Probe 2 setup, Pokeys57cnc

« on: February 15, 2021, 03:05:26 PM »

No my freind electric rules ,if you want use 2 probe same input , parallel ,only NO can use ,if you want tske chance can use both in line and then both shuld be NC

270

Mach4 General Discussion / Re: cant load m4prof files on last version from previus version

« on: February 15, 2021, 08:36:58 AM »

But in old version all work, something on new version cant accept it