5591
General Mach Discussion / Re: Spindle runs in Parallel mode OK but not in ESS ?
« on: March 28, 2013, 04:14:11 PM »
Ok if the spindle speed is as requested then thats fine. I always did things a different way to the way Greg said but I think the end results were the same. Talking about this has jogged my memory
Step/Dir spindle control from the SS and ESS has never been perfect and Greg always said he would have a look but sadly never did as obviously there were other things that affected more people that he worked on instead. Anyway what that brought to mind was I had similar issues in some plugins and went back to 10a plugin. What would happen is the spindle would be running fine but if there was a heavy load on it all of a sudden it would E-Stop, so kind of sounds like it may be a similar thing to your problem. Maybe try the 10a plugin and see if it helps.
Hood
Step/Dir spindle control from the SS and ESS has never been perfect and Greg always said he would have a look but sadly never did as obviously there were other things that affected more people that he worked on instead. Anyway what that brought to mind was I had similar issues in some plugins and went back to 10a plugin. What would happen is the spindle would be running fine but if there was a heavy load on it all of a sudden it would E-Stop, so kind of sounds like it may be a similar thing to your problem. Maybe try the 10a plugin and see if it helps.
Hood