11991
General Mach Discussion / Re: Motors will not spin
« on: March 29, 2011, 11:47:54 AM »
As the motors seem to be holding with the only difference seeming to be a new xml then I assume an enable is being used, not looked at the xml though. If that is the case then I would have thought the motors would be in a free state when the drives were not enabled. I am however more used to servos so that may be different for steppers.
The error sounds like there is no driver installed. Have a look on the diagnostics page and see if there is a frequency showing and also a time in int.
Hood
The error sounds like there is no driver installed. Have a look on the diagnostics page and see if there is a frequency showing and also a time in int.
Hood