Hi hood
I think I may have made a mistake
Found computer has about 6 different profiles in it.
I picked on one and looked at m6start.mls had to pick a program to open it into this changed all the icons on most of the folders now I don't know what to put them back to or if I need to.
this is what I found in the one I chose
Tool=getselected tool()
x=Get tool change start(0)
y=get tool change start (1)
z=get tool change start (2)
a=get tool change start (3)
b=get tool change start (4)
c=get tool change start (5)
SafeZ=get safe Z()
If safe Z>z then straight transverse
Set current tool(tool) x,y,SafeZ,a,b,c
Before I go and look any further goes this look like what I am looking for or is it just a standard piece of software
did notice that auto tool change had been selected in I think the logic settings
Bert