11
General Mach Discussion / Re: New/old DIY CNC upgrade?
« on: June 22, 2023, 08:46:04 PM »
Hi,
how about posting the manual of the breakout board.
Most PWM outputs of breakout boards 'take' 10VDC from the VFD (device to be controlled) and processes it to a varying 0-10VDC voltage using PWM.
If you are expecting your breakout board to produce 0-10VDC.....but without......the raw input voltage to process than I think you'll be disappointed.
Craig
how about posting the manual of the breakout board.
Most PWM outputs of breakout boards 'take' 10VDC from the VFD (device to be controlled) and processes it to a varying 0-10VDC voltage using PWM.
If you are expecting your breakout board to produce 0-10VDC.....but without......the raw input voltage to process than I think you'll be disappointed.
Craig