5731
General Mach Discussion / Re: Laptop with parallel Port
« on: October 11, 2012, 01:10:52 PM »
Hi Darryl,
This CNC stuff is going to be an adventure with much to learn but it will certainly keep the brain active.
I am going back a few years but this is probably the first item I made with my CNC machine.
The GCode was produced with the free software G-Simple http://www.gsimple.eu/
It was made from 1.8mm thick engraving laminate and cut with a 2mm dia. Endmill – the 6 pieces then slotted together and fixed with cyano super glue.
The cube has no practical purpose but if you want to give it a try the GCode file is attached.
Tweakie.
This CNC stuff is going to be an adventure with much to learn but it will certainly keep the brain active.
I am going back a few years but this is probably the first item I made with my CNC machine.
The GCode was produced with the free software G-Simple http://www.gsimple.eu/
It was made from 1.8mm thick engraving laminate and cut with a 2mm dia. Endmill – the 6 pieces then slotted together and fixed with cyano super glue.
The cube has no practical purpose but if you want to give it a try the GCode file is attached.
Tweakie.