2481
General Mach Discussion / Re: THC Codes upset corners???
« on: April 09, 2014, 02:18:21 PM »
Lol
One good thing I do have going is a dual-purpose z height probe, first position is probe height, 3mm more is a limit switch so if it did ram the torch, the most that could happen is an e-stop
I have a lot to learn methinks, at least it's all playing nicely together now, the hypertherm was a revelation and solved a massive amount of grief with HF issues.
The hard part is learning blind, it would be so much easier to just have someone there to say "do this" or "do that" etc, that is why I have so many odd questions
One good thing I do have going is a dual-purpose z height probe, first position is probe height, 3mm more is a limit switch so if it did ram the torch, the most that could happen is an e-stop
I have a lot to learn methinks, at least it's all playing nicely together now, the hypertherm was a revelation and solved a massive amount of grief with HF issues.
The hard part is learning blind, it would be so much easier to just have someone there to say "do this" or "do that" etc, that is why I have so many odd questions