I used multipass and nesting wizards couple weeks ago with great success.
This week I tried them again with another part and the results are baffling to me. Rather than following the geometry for each pass, it makes several irrelevant (to me) lines. I thought it was in the part CAD, so I made up just a simple rectangle with fillets at the coners and it does the same thing. Without multipass it is fine.
I figured that I must have changed the configuration file to cause this. So, I reinstalled Mach3 with no better affect.
If someone could take a look, I would appreciate it.
With the nesting wizard, the repeated parts are offset in X and Z, even though X is zero in the screen. I'm not sure what the X offset value comes from, since it isn't the same as Y that I entered. I'm hoping what is wrong for multipass is same for nesting.
Steve.