3741
General Mach Discussion / Re: Nothing seems to work!
« on: March 03, 2016, 05:06:38 AM »
Config. / Ports & Pins / Motor Outputs - change Direction Low Active state for your X axis.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Thanks if I have anymore questions I will get back to you you are the only one that I get a straight answer from.
Hi is it best to wire all the limit switches in series including the home switches. By this I mean just using 2 wires so all the switches are all connected in 1 circuit with only using 1 pin.