3691
General Mach Discussion / Re: smooth stepper
« on: March 17, 2016, 03:44:30 AM »if i was to go smooth stepper i could use more than one breakout bored for auto tool change and other stuff
Yes.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
if i was to go smooth stepper i could use more than one breakout bored for auto tool change and other stuff
Example Scenario: If i set min spindle speed to 0, and Max spindle speed to 5000, and the Max Motor Speed to 3600. will mach figure out how much voltage (between 0-10V) to send the vfd using some formula and the 5000 and 3600 values from the Max Spindle and Max Motor Speed, if i command an m3 s2500, or m3 s950
Then had to sign in to run Mach3 as if Mach3 had just been installed.
If it is not a mach4 problem then why when I change the pulley settings, does it affect the actual rpm?