2911
General Mach Discussion / Re: Mach3 on a laser cutter...
« on: March 14, 2017, 05:41:48 AM »
Looks like more fun then Dave.
Depends on the maximum axis speed of your laser cutter but I would say Yes Mach3 is fast enough.
Yes, using the S### command
That is a matter of opinion - I would not say Mach3 is better but I think I have managed to do anything that the built-in controllers can do.
Unknown, my laser is only 40 Watts.
Tweakie.
Quote
Is it fast enough?
Depends on the maximum axis speed of your laser cutter but I would say Yes Mach3 is fast enough.
Quote
Does it do PWM power control?
Yes, using the S### command
Quote
Is it better than the built-in controllers found on eBay laser cutters?
That is a matter of opinion - I would not say Mach3 is better but I think I have managed to do anything that the built-in controllers can do.
Quote
Anyone running a 50-60W laser on Mach3?
Unknown, my laser is only 40 Watts.
Tweakie.