1
General Mach Discussion / Re: UC100 - Problems getting Mach 3 to talk to the mill
« on: July 14, 2017, 04:39:24 AM »
UPDATE:
The UC100 works now.
Settings are; Max step rate @ 50kHz
Ports and pins;
No parallel port selected.
I had to change the Z-axis Dir & Step both to Low Active
(before only the Dir was selected)
Also the Y-axis change to Dir Low active, to change the direction of movement.
(before it was not selected)
Now all axis run normal.
Why I had the play with the Dir & Step settings I do not know.
The UC100 works now.
Settings are; Max step rate @ 50kHz
Ports and pins;
No parallel port selected.
I had to change the Z-axis Dir & Step both to Low Active
(before only the Dir was selected)
Also the Y-axis change to Dir Low active, to change the direction of movement.
(before it was not selected)
Now all axis run normal.
Why I had the play with the Dir & Step settings I do not know.