Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: oxxyfx on April 01, 2011, 07:49:30 PM
-
Hello,
I just recevied mu pokeys55T today. I isntalled it on the CNC computer, the software, upgraded the firmware and I installed the plugin to MACH 3 as well. However when I am going to enable it in the Plugin control - the plugin is not there. What am I missing?
Thanks,
Oxxy.
-
My bad. Found it, the installation directory for Mach3 was not in the default Mach3 - so the pokeys plugin was not installed where it was expected.