6561
FAQs / Re: help needed with emco pc mill rebuild
« on: September 01, 2011, 02:47:36 AM »
If the steppers are Sanyo 8 wire then this information should help you with identifying the connections http://www.piclist.com/techref/io/stepper/wires.htm
There are many variants of the yuk board instructions but these are probably the best http://www.savebase.com/infobase/downloads/TB6560/TB6560_4Axis_Driver.doc
Hope this helps.
Tweakie.
There are many variants of the yuk board instructions but these are probably the best http://www.savebase.com/infobase/downloads/TB6560/TB6560_4Axis_Driver.doc
Hope this helps.
Tweakie.