I Have 3 machined running Mach 3 and they all do this. When pressing an external start button My spindle comes on as it is suppose to, but some times I get a momentary output on output #1 It lasts for maybe .5 seconds. If I cycle the maching using the on screen start button it never dose this. I have try ed changing the pin# and the output #, ran shielded wire to my start button, and it still dose it. Here is my G code program it is very simple
M3
X -00.000 Y00.00000 Z00.00000 F550.00
M11 P4 -----> this one too will blink on for just a .1 of a second this is my machine on
G1 X -00.010 Y00.00000 Z00.00000 F030.0
M11 P1 ------> This is the output, it turn on at the same time as the spindle and stays on .5 seconds then shuts off and then turns back on
G4 P00.34
G1 X -04.8000 Y00.00000 Z00.00000 F090.0
M10 P4
M10 P4
X -05.7000 Y00.00000 Z00.00000 F800.00
M11 P5
G4 P0.9
X -05.7500 Y00.00000 Z00.00000 F800.00
M11 P7
X -05.7600 Y00.00000 Z00.00000 F800.00
G4 P00.2
M10 P7
M10 P1
X -05.7650 Y00.00000 Z00.00000 F800.00
G4 P0.2
X -00.000 Y00.00000 Z00.00000 F800.00
M30
M30
My start button is on oem trigger #1 and set on active low..
I am using a simple brake out board and an amplification/printer port protection board,,
where have i gone wrong
thanks to all
Josh