6981
General Mach Discussion / Re: Mach 3 turn questions from a very experianced mach 3 mill guy (bobcad user)
« on: October 20, 2008, 06:46:33 PM »
HI Shawn,
Here is a simple file created from the OD TURNING WIZARD (SHAWN_TURN which shows values and has some comments in green),
the gcode file as generated by the wizard ( SHAWN_.TXT), and values added into the DRO for the axis position and part zero ( SHAWN_TURNmt). The gcode just turns a 1" dia stock down to 0.5" dia using only a few cuts with no finishing cut for simplicity.
As discussed, if you draw it in diameter mode and generate code from bobcad ( which i know nothing about) then work in diameter
mode in mach turn so there is no confusion. You can set diameter mode in Mach Turn via Config>ports&pins>turn options by putting a check in the x mode / diameter box.
Take a few moments and look at the code, note the G90 in the first line and also the first GO move in the 3rd liine.
Dry run the file in Mach Turn. Better than words, I want you to dry running it a few ways. Watch the tool path on the screen.
1. run the file using 1.000" for x Axis position.( just as shown in the screen shot SHAWN_TURNmt)
2. " " 0.000" "
Go back into the config anad change the x mode to RADIUS
3. run with values as 1. above
4. run with values as 2. above
change back to diameter mode
now change values for the part zero say 1.00" for both and rerun 1. above
RICH
Here is a simple file created from the OD TURNING WIZARD (SHAWN_TURN which shows values and has some comments in green),
the gcode file as generated by the wizard ( SHAWN_.TXT), and values added into the DRO for the axis position and part zero ( SHAWN_TURNmt). The gcode just turns a 1" dia stock down to 0.5" dia using only a few cuts with no finishing cut for simplicity.
As discussed, if you draw it in diameter mode and generate code from bobcad ( which i know nothing about) then work in diameter
mode in mach turn so there is no confusion. You can set diameter mode in Mach Turn via Config>ports&pins>turn options by putting a check in the x mode / diameter box.
Take a few moments and look at the code, note the G90 in the first line and also the first GO move in the 3rd liine.
Dry run the file in Mach Turn. Better than words, I want you to dry running it a few ways. Watch the tool path on the screen.
1. run the file using 1.000" for x Axis position.( just as shown in the screen shot SHAWN_TURNmt)
2. " " 0.000" "
Go back into the config anad change the x mode to RADIUS
3. run with values as 1. above
4. run with values as 2. above
change back to diameter mode
now change values for the part zero say 1.00" for both and rerun 1. above
RICH