Hi to all,
I design a part in Rhino V 3.0 (in mm) and I imported in LCam. I generated the g-code. When I imported in Mach3 V R2.0.036 (setup is in mm also) my design is more larger than original design.
How can I fix that?
Another question - if I jog some place in my table and regen the toolpath:
How can I "tell" the DRO to start from that point?
The mil start to cut from a point which it is in g-code
N25 G90 G80 G40 G91.1
N30 G0 Z0.0000
N35 X19.8605 Y26.3802
N40 Z0.1000
N45 M3
N50 G1 Z0.0000 F1.00
N55 X35.3117
Thank in advance
GB