Hello Chaps,
Mach3 turning.
I do not have any measuring device on my lathe that measures the RPM
therefore i have been using G94 ( units per minute)
I would prefer to use units per revolution ( so as better to control the
surface finish)
Does Mach3 use the F word (as set in the gcode) to determine the feed per rev. or is it
dependant on feedback of the actual RPM from some odometer type device?
In other words if i code g95 f100 and feed as .025 - will the cut be the same as if
i code g95 f1000 and feed as .025 ?
many thanks