7781
General Mach Discussion / Re: replacing manual valves with electric valves?
« on: October 29, 2010, 11:57:26 AM »
Dan,
If you decide to use one of those valves then to switch it (open/close) an SSR, similar to this would be ideal. They are opto isolated and can be driven direct from the BoB (M8/M9 etc) and they switch ac loads with extremely low electrical noise.
Tweakie.
If you decide to use one of those valves then to switch it (open/close) an SSR, similar to this would be ideal. They are opto isolated and can be driven direct from the BoB (M8/M9 etc) and they switch ac loads with extremely low electrical noise.
Tweakie.