1631
General Mach Discussion / Re: Limit Switches working backwards
« on: April 14, 2007, 06:30:09 PM »
OK, Loui
Under Config, Ports & Pins, Motor outputs, Have you assigned a Port # 1 to all Axises, Step/Dir Ports. Right side of window and Apply.
Same window, Changed the Dir/Step Low Active to different State.
Same window, Inputs Tab, Set up port Pins for your axises, changed the Active Low State.
Diagnostics Page should show switch activity when Pressed.
Take a Look, Chip
Under Config, Ports & Pins, Motor outputs, Have you assigned a Port # 1 to all Axises, Step/Dir Ports. Right side of window and Apply.
Same window, Changed the Dir/Step Low Active to different State.
Same window, Inputs Tab, Set up port Pins for your axises, changed the Active Low State.
Diagnostics Page should show switch activity when Pressed.
Take a Look, Chip