5641
General Mach Discussion / Re: Spindle runs in Parallel mode OK but not in ESS ?
« on: March 24, 2013, 02:01:53 PM »
Maybe try reducing the pulse width in the ESS plugin for the spindles step/dir signal.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Thanks for the link Hood,
But DAMN, looks like I really need to learn to make a pcb as the componets you suggest seem to always need one. BTW, that is a really neat, clean & professional looking electrical cabinet you showed Dan there, looks like I'm getting advise from an EE, I better pay attention!
Thanks , Rick
That's only for the Estop or a drive fault also? And where does it get its signal from?
Dan