I haven't used Mach4 Lathe very much yet But the other day I had the PID working pretty good. It was holding the rpm pretty close. I used one of the cutting cycles and it defaulted to css mode. Now whatever I do the rpm is way high, If I set rpm to 200 it runs at around 530 rpm and if I move the x axis in smaller and run G97 the rpm speeds up. I've tried everything I can think of. I shut everything down, the program, the smoothstepper and the machine. and started again. Still runs way faster and will speed up with smaller x axis values. The code list at the bottom shows G97 which as far as I know is fixed rpm.
What am I doing wrong.
Attached the screen capture.
Help please.