11
General Mach Discussion / Re: Setup for homing X and Z but not Y
« on: December 07, 2012, 10:29:12 AM »
Hood - Yes the Z goes green after it homes.
Overloaded - I am using the standard Mach four axis screen set, nothing customized.
strong6515 - I can try that quickly. But if it works then I would say this is a bug in Mach.
BR549 - How do I do that? Is that accessed through the screen designer?
Overloaded - I am using the standard Mach four axis screen set, nothing customized.
strong6515 - I can try that quickly. But if it works then I would say this is a bug in Mach.
BR549 - How do I do that? Is that accessed through the screen designer?