Messages

2061

General Mach Discussion / Re: A axis and Mach3R2.0.005

« on: October 28, 2006, 08:34:00 AM »

I think you have like 3 things that you are looking to get fixed... could you please list one and explane what is wrong and we will work on them one at a time

Thanks
Brian

2062

General Mach Discussion / Re: What is a good feed rate?

« on: October 28, 2006, 08:25:39 AM »

Also run a driver test and see if you have a nice flat line

2063

LazyCam (Beta) / Re: LazyCam ver 2.64 and G(Mode) generation of G41, G42

« on: October 27, 2006, 09:38:26 PM »

Thank you that is a very big help!!!

2064

VB and the development of wizards / Re: Soft Limits in a Macro

« on: October 27, 2006, 09:37:07 PM »

To do stuff like that I look at the screen is the designer and get the codes from the screen

For example:

if(GetOEMLED(23) then
'This code will run IF the softlimits are on...
end if
DoOEMButton(119) 'This will change the state of the softlimits


That should do it

2065

LazyCam (Beta) / Re: LazyCam ver 2.64 and G(Mode) generation of G41, G42

« on: October 27, 2006, 11:35:56 AM »

we are working on a new rev and it is on the list

Thanks
Brian

2066

General Mach Discussion / Re: Few forum changes

« on: October 27, 2006, 11:31:32 AM »

Benny I am at the point where I wil only be able to check the Mach3 Lcam and VB every day It just takes to long to check all of them


Is there a way to make it so it works in my Email

2067

General Mach Discussion / Re: run amuck on STOP

« on: October 27, 2006, 11:18:24 AM »

Bill,
Stop is not what you should be doing.... Use Feedhold and tell me  if you have trouble. Feed hold is a Pause and Stop is if you are going restart the file from the start... I think that the stop button shoulf rewind the file ( that is what I have on my system) Stop should only be used IF you are in a feed hold OR at a tool change to kill the running of the file

Thanks
Brian

2068

LazyCam (Beta) / Re: Cutting order

« on: October 25, 2006, 11:55:44 PM »

Sounds like a bug to me ... It is on the list


it is going to take a bit to fix it as I have a TON of work that I have to do

2069

LazyCam (Beta) / Re: LazyCam ver 2.64 and G(Mode) generation of G41, G42

« on: October 25, 2006, 11:53:03 PM »

Thanks I will see if I can find some of that in the next few weeks

2070

LazyCam (Beta) / Re: inf lazycam 2.64 mach3 rc2.0.g

« on: October 25, 2006, 11:50:20 PM »

I will test it in the next few days now that I have your XML

Thanks
Brian