Messages

1711

NC Pod / Re: Not returning to zero

« on: January 15, 2007, 10:24:01 AM »

Dave and/or I will be sure to post that it is out here

1712

NC Pod / Re: Not returning to zero

« on: January 15, 2007, 09:49:15 AM »

Set your servo time to .00087 and you should be good

I have been running tests and it is working well for position. you need to have the latest software on everything.

1713

General Mach Discussion / Re: couple of program quirks.

« on: January 15, 2007, 09:39:02 AM »

It will be all fixed after the homing is done... tells you how far out you were...

1714

General Mach Discussion / Re: Install of Mach3 Ver 2.033

« on: January 15, 2007, 09:31:04 AM »

That is a good thing to know... 
Thank you for the info
Brian

1715

NC Pod / Re: Welcome To The NC Pod Development, Discussion and Support Topic

« on: January 14, 2007, 09:37:41 PM »

There is a pulse timing problem with the Pod... I had it hooked up to the scope today and tested it to the 9's

1716

LazyCam (Beta) / Re: New LazyCam has lots of problems

« on: January 14, 2007, 09:36:15 PM »

There is not much that we can do about the DXF's that don't load We have an OCX that we are running... therefor we can't do much.

1717

VB and the development of wizards / Re: output register (1040) over Modbus and VB

« on: January 14, 2007, 09:32:19 PM »

To get the plugIn you will have to mail Peter H. ... I don't have a copy, I just know there was one done.

1718

General Mach Discussion / Re: couple of program quirks.

« on: January 14, 2007, 09:27:53 PM »

The run form here problem... you need to type in the line number that you would like to start at and press the run from here button... this should do it for you... You need to have a license file to have this work BTW

1719

General Mach Discussion / Re: CNC Router step issues

« on: January 14, 2007, 09:24:49 PM »

Driver test looks okay... I think it is time to start looking for noise in the system

1720

General Mach Discussion / Re: A axis preview won't rotate in realtime ????

« on: January 14, 2007, 09:22:16 PM »

That was a small bug and we knew about it Should be fixed in the next rev...