2731
Mach Screens / Re: G-Code tool change buttons?
« on: March 22, 2014, 12:10:24 PM »
Open the screen in a screen designer, and setup the button to execute g-code, and enter the T0101 in the g-code box.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
First issue is the machine will be chugging along and then just stop. No repeatability and completely random.
Mike,
I am in the same position you were a wee while ago. I am trying to figure out the zeroing procedure for my new router. Is there any chance that you could post the code you are using now for me to see? I would be really really grateful!
I am also looking to find out how I go about setting the machine up to implement tool changes. Also to return the gantry to the rear of the table when the job is finished so that I can remove and replace materials without the gantry getting in the way....
Any help would be appreciated.