3921
General Mach Discussion / Re: Creating G-Code
« on: January 13, 2016, 01:34:06 AM »Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
This product is best left in someones garage or basement as a 'toy'....it does not belong in any industrial environment regardless of anyones personal opinion to the contrary.
I've been out in the garage and I've used Feedhold, then Cycle Start 4 or 5 times. I've never had a problem doing it that way. That's generally the way it's intended to work. Once you hit Stop, you usually need to use Run From Here to continue.