Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: birillo1959 on February 12, 2024, 12:51:29 PM

Title: delay the start of processing
Post by: birillo1959 on February 12, 2024, 12:51:29 PM

Good morning
I would like to delay the processing after turning on the spindle (m3) to give it time to reach the spindle revolutions. I tried in " config \port and pins\spindle setup\cv delay spin up and cw delay spin down) to insert various values from 1 to 10 but nothing changes
I'll start by saying that I use UC400ETH, Windows XP everything else works fine, is it possible to modify M3, any ideas/suggestions?
any advice is welcome.

Title: Re: delay the start of processing
Post by: TPS on February 13, 2024, 12:42:31 PM

time depends on setting in:

Config -> General Config -> General Cinfiguration -> G04 dwell in ms

if this is enabed also "delay spin up" will be in ms

Title: Re: delay the start of processing
Post by: birillo1959 on February 13, 2024, 01:10:26 PM

ok, actually in "Config -> General Config -> General Cinfiguration -> G04 dwell in ms" it is enabled, do you recommend disabling it or entering 5000?
thanks for the reply regards

Title: Re: delay the start of processing
Post by: TPS on February 14, 2024, 01:20:26 AM

either way is ok.