Yes, I am running a G-Rex. Or, at least I'm trying to. It has a lot of idiosyncrasies, like this limit switch thing. I've attached the xml file.
I just ran into another issue. I wrote this bit of code I call m109 to turn an air cylinder on.
ActivateSignal(OUTPUT9)
It worked fine yesterday and today it triggers a reset. It's exactly like m107 and m108 which still work fine. I need a break.
While you're looking, how about taking a peek at this snippet of code.
While IsActive(Input2)
ActivateSignal(OUTPUT8)
Wend
While IsActive(Input3)
DeActivateSignal(OUTPUT8)
Wend
This probably belongs in another section but why start another thread? This code cycles an air cylinder. It works fine when run it alone but when it's put in a program, Mach3 won't load. It gets to the m110 and just stops loading. Any idea on how this can be fixed?
Any and all suggestions will be greatly appreciated,
Thanks,
Walt