Messages

2851

General Mach Discussion / Re: SURFACE WIZARD

« on: June 03, 2006, 10:09:48 PM »

I think you guys are holding out on me you have a better wizard than I have... I did the base code of that wizard a few years ago and have not worked on it in about 1.5 years

If you guys find a problem and post the wizards set file I will fix it 

Thanks
Brian

2852

General Mach Discussion / Re: Bug in Mach 3 or Bug in Me?

« on: June 03, 2006, 08:54:18 PM »

There is nothing like that That is a good idea but there are SO many things that people do with Gcode! If you loada bad file into Mach3 it will give you an error and tell you what line it is on.

If you have a problem or need to ask a question about a file there are many people here that can help!

I am a Samuel Adans guy my self mmmm... I think I am going to have to get up and get one now 

Brian

2853

LazyCam (Beta) / Re: LazyCam won't load

« on: June 03, 2006, 07:15:19 PM »

There will be a new rev in you mail to test in the next day or so... I have a bunch of the code ripped up at that moment. (Fixing more bugs)

Thank you
Brian

2854

General Mach Discussion / Re: What file extension should I use for Mach3

« on: June 03, 2006, 07:13:03 PM »

Great! you are going to have to post a pick of your work love to see the great work you all doing!

2855

General Mach Discussion / Re: Using parallel port

« on: June 03, 2006, 07:11:34 PM »

I have had that happen to me in the past too  I took the loppers to the cable after that 

2856

General Mach Discussion / Re: Configuring servo spindle

« on: June 03, 2006, 07:10:23 PM »

You can do this under ports and pins. I think it is encoder 3 that you have to set.

2857

General Mach Discussion / Re: SURFACE WIZARD

« on: June 03, 2006, 07:09:08 PM »

The wizard that I have here has WAY less stuff on it... But it looks like you can change the rough and finish feed rates.

2858

General Mach Discussion / Re: Visual offset in tool/job display showing

« on: June 03, 2006, 07:03:29 PM »

Here is your program with a G52 added in... This is a way to shift the Gcode program

2859

LazyCam (Beta) / Re: LazyCam won't load

« on: June 03, 2006, 09:48:01 AM »

Line 9 should not need the XY pos  but the No G0 at the start is no good It is getting fixed this min!
Thank you again
Brian

2860

General Mach Discussion / Re: Visual offset in tool/job display showing

« on: June 03, 2006, 09:45:10 AM »

There is a 12inch shift in the X positive direction in your program that you got from Vcarve... I can tell you how to get this to cut where you would like on the table but it looks like a problem in Vcarve (I have never used it). There are other on the forum that use it and they may be able to help.

Thank you
Brian