7881
General Mach Discussion / Re: CNC conversion to Mach3 possible?
« on: August 09, 2012, 05:13:34 AM »
Ok if analogue then thats good as the Siemens stuff is usually good so should do you fine.
As for controller you have a few options as mentioned above, I like the look of the CS-Lab hardware but have not tried it. I am supposed to be taking delivery of their Step/Dir 6 axis controller today but you would need the Analogue version which I dont think is on sale yet.
Hood
As for controller you have a few options as mentioned above, I like the look of the CS-Lab hardware but have not tried it. I am supposed to be taking delivery of their Step/Dir 6 axis controller today but you would need the Analogue version which I dont think is on sale yet.
Hood