3401
General Mach Discussion / Re: Xhc control card connecting to sangmutan bldc spindle control
« on: August 20, 2016, 07:09:13 AM »
In the folder / file ; C:\ Mach3 / macros / Mach3Mill / m4.m1s
Add the line ActivateSignal(OUTPUT4) or whatever Output# you require – calling M4 will then activate the Output# defined in Spindle Setup and the Output# you have chosen here.
Obviously a similar procedure may be necessary for turning it off.
Tweakie.
Add the line ActivateSignal(OUTPUT4) or whatever Output# you require – calling M4 will then activate the Output# defined in Spindle Setup and the Output# you have chosen here.
Obviously a similar procedure may be necessary for turning it off.
Tweakie.