2701
General Mach Discussion / Re: Tool plunges into project too deep
« on: June 05, 2017, 03:52:34 AM »
As you suspected, there is nothing wrong with your Gcode - it runs just fine here.
Check that your cutter is secure in it's collet and not moving.
When the problem occurs stop the work and check your Z zero position.
If Z zero is now below the work surface a likely cause is loosing steps on the +Z travel - try reducing your Z axis Velocity and Acceleration settings in Motor Tuning by 50%, save the changes. Then, does the problem still exist ?
Tweakie.
Check that your cutter is secure in it's collet and not moving.
When the problem occurs stop the work and check your Z zero position.
If Z zero is now below the work surface a likely cause is loosing steps on the +Z travel - try reducing your Z axis Velocity and Acceleration settings in Motor Tuning by 50%, save the changes. Then, does the problem still exist ?
Tweakie.