Messages

3401

General Mach Discussion / Re: Suggestion required for Bridgeport CNC series II Boss 6

« on: March 15, 2006, 09:02:06 PM »

Jerry we are running Mach3 on a BP series 2 here in the states. It has been a good runnig mill and we make many parts on it about every day!
So go with Mach3
I also run an EZTrack that is the same as an EZpath and it SUCKS HARD!!! I hate that thing!

3402

General Mach Discussion / Re: Wrong way "Z"

« on: March 15, 2006, 08:59:31 PM »

under the ports and pins change the Active high state of the Z axis Dir pin

That should fix you right up.

3403

General Mach Discussion / Re: Help with older Techno Isel

« on: March 15, 2006, 08:58:08 PM »

Are you looking to wire up the stepper drives and build the control? Or are you looking for something that you can plug the computer and motors into?
Building the control is the least expensive...

3404

General Mach Discussion / Re: what does "axis scales ar NZ" mean

« on: March 14, 2006, 10:01:01 PM »

You have a scale DRO that is not reading zero Type in zero and press enter...

3405

General Mach Discussion / Re: I/O card

« on: March 14, 2006, 09:59:28 PM »

No Sorry. But there is the Grex (G100) from Geckodrive.com. This will be run by Mach 4.

3406

General Mach Discussion / Re: Laptop Driver problem

« on: March 14, 2006, 06:58:20 PM »

There is no way that I know of...

3407

General Mach Discussion / Re: O.T. Need some advice on tapping LOTS of 1/2 holes.

« on: March 13, 2006, 01:00:09 PM »

Check this out http://www.tapmatic.com/index.htm

Do you know what taps you are going to need??? A hand tap isn't going to do it

3408

General Mach Discussion / Re: Getting New Installation Going

« on: March 12, 2006, 10:10:38 PM »

Art should be back at it tomorrow I will tell him that we need to have his help.

3409

LazyCam (Beta) / Dot Width Deffusion (for cutting pics)

« on: March 12, 2006, 08:43:02 PM »

I know have LazyCam outputting code for dot width diffusion This is a nice fast way to put out t picture... At this point you are going to have to use a 90 deg V bit but at some point I will add in code so you can pick any point angle. I hope to have a sample in the next few days...

I am working on points and drilling so once that is done I think I am ready for  release...

Looking good...
Brian

3410

General Mach Discussion / Re: Display problems when nesting

« on: March 12, 2006, 08:38:07 PM »

Hood,
Could you please post both Gcode files so I can test them ? One without nesting and one with...