Messages

1431

Galil / Re: Is Ridgid Tap possable with Galil?

« on: July 30, 2010, 02:19:02 AM »

I put the code in there to do it, but it is NOT tested.  Try it at your own risk.  Maybe with something soft to start with. 

Steve

1432

Galil / Re: galil and backlash compensation

« on: July 30, 2010, 02:14:43 AM »

The Galil plugin just follows what Mach says.  If Mach is correcting for backlash, then the Galil plugin would not hinder it.  Test is by setting backlash to some insane value.

Steve

1433

Galil / Re: Mach3 + Galil

« on: July 30, 2010, 02:11:34 AM »

M call, unfortunately. 

1434

Galil / Re: Galil + Mach issue with G moves

« on: July 30, 2010, 02:07:18 AM »

LaserCut,

Do you have the axes mapped in the plugin config?  And also set to the correct motor types?  I know what MAT's issue was and it was specific to his 1425 controller.  I have a 2173 working perfectly, so I don't think your controller is an issue. 

Steve

1435

Galil / Re: Galil dmc1425 doGmove issue

« on: July 30, 2010, 02:03:38 AM »

This should be fixed now.

1436

Galil / Re: Z axis to digital output

« on: July 30, 2010, 01:58:02 AM »

I'm working on this now.  I'll post up when it's done.

1437

Galil / Re: Mesa card plugin

« on: July 30, 2010, 01:54:22 AM »

It should have most of the functionality of the Galil plugin.  It moves motors, hits the numbers, etc...  It just hasn't been properly tested on a real machine.  

I am building a small mill to test it on, but life has gotten in the way.  If I had a couple of weeks of free time, I'd be set.  I had a few people lined up to test, but they all fell through.  

Steve

1438

Galil / Re: DMC-2030 for lathe

« on: July 29, 2010, 10:57:06 PM »

Haik,

I don't believe the drivers are properly installed.  The only way windows recognizes a device is if a driver is installed or there is at least a modicum of an INF file to give it information.  It looks like Windows recognizes the 2 port USB hub that is in the controller.  So it's either the driver is not there or the USB control has been disabled.  Look at DIP switch #10.  It should be in the off position.

Steve

1439

Galil / Re: Mesa card plugin

« on: July 18, 2010, 11:37:21 PM »

You want to test it?  Let me know what you have.

Steve

1440

Galil / Re: Mitsubishi HF-SE Ac servos and drives.

« on: May 10, 2010, 12:29:53 AM »

The Yaskawa stuff is pretty nice,isn't it?