Hey, thanks for the reply. I am way too new at this to know if it is G31 or G28. I am using BobCad and set it using a window for this feature.
Seems like every day it does something new. Yesterday was the pierce and not moving. Today I was cutting and it started perfectly, it was making a long cut, 1/2 way through it the torch went out raised to the rapid ht. completed the run, weht to the next pierce and started up again like normal.
I re-posted the design and it started by raising the torch to go past the stop. This might be my error, I may have set the Rapid to 5. instead of .5.
I will have to find out what G it is to find out where the error is.
You asked what plasma I am using. I have a Thermal Dynamics A40, cutting with air and cutting 14 ga. mild steel.
Any help is gratefully accepted.