421
General Mach Discussion / Re: Tool Offset Macro...
« on: August 25, 2016, 06:48:33 AM »
Ah ok, not so good.
What about having a routine.
Have Out of reset and Home it (set zero)
Put in Reset and move it onto tool.
Take back out of Reset and press the button to update the offsets?
Could maybe even be integrated into the button with a few message boxes informing you what to do next.
Or you could splash out for the Enc module and have rigid tapping as well
Hood
What about having a routine.
Have Out of reset and Home it (set zero)
Put in Reset and move it onto tool.
Take back out of Reset and press the button to update the offsets?
Could maybe even be integrated into the button with a few message boxes informing you what to do next.
Or you could splash out for the Enc module and have rigid tapping as well
Hood