Tonight I hooked up the laser the camera and I:
1st, I calibrate and I get a Scan Angle. (mixed results and never got the correct angle and correct z distance at the same time)
2nd, I change the feed rate to 5
3rd, I change the StepOverY to .01
4th, I changed the ScanY to 3 (because my object is 2 inches wide)
5th, I press Scan (The table moves 3 inches at 5 in/min then returns).
6th, I run MachCloud and view the results. My results actually look like my object except the thickness is zero. My cloud is laying on the zero surface.
I'll try to get an image in just a minute.
I've got problems viewing the video on screen both left and right hand monitors.
I'm not sure what I'm supposed to be seeing in the right monitor. What ever I'm seeing, it doesn't look correct.
There is a slider between the monitor screens. What does this do. When I raise it, I seem to get some speckles on the right screen.
The format and source buttons are not reliable. I crash about half time when I touch these buttons.
Those are some of my results.
Over all, success, I'm making progress.
Dave