4681
General Mach Discussion / Re: mach to usb DAC from radio shack?
« on: July 10, 2013, 02:58:15 AM »
Maybe the standalone board uses a different method of converting the signal to an analogue output than the integrated one, I have no idea. Personally however if I was unhappy with one of them I would be trying to get a resolution from the vendor and if that was not possible then I dont think I would be considering buying another from that same vendor in the offchance that it may be better. Of course that is just my thoughts, I have no experience with these products at all so cant say whether they are good or bad.
I have used a step/Dir to analogue board from Peter Homann and it worked very well and was very linear in operation but that is the only stand alone board I have used for spindle control.
As for plugins, C++ I believe it is, but it is beyond my skill-set so really I have no idea.
You will find some info regarding plugins here
http://www.machsupport.com/software/downloads-updates/
and
http://www.machsupport.com/forum/index.php/board,28.0.html
Hood
I have used a step/Dir to analogue board from Peter Homann and it worked very well and was very linear in operation but that is the only stand alone board I have used for spindle control.
As for plugins, C++ I believe it is, but it is beyond my skill-set so really I have no idea.
You will find some info regarding plugins here
http://www.machsupport.com/software/downloads-updates/
and
http://www.machsupport.com/forum/index.php/board,28.0.html
Hood